How to add Yale Lock?

    Before adding Lock to B.One App, follow instructions mentioned below to Register Master PIN and User PIN for Yale Lock:

    Master PIN Setup:

    • Touch the screen with the back of your hand or fingers to activate.

    • Press any key. Lock Response: “Register Master Code; press the # key to continue”.

    • Press the # key. Lock Response: “Enter a 4 to 8 digit PIN code followed by the pound key”.

    • Enter new 4-8 digit Master PIN code followed by the # key.

    • Lock visually confirms PIN code selection, announces “Registered”.

    Note: This initial step must be performed upon installation or after resetting the lock to factory default. Programming and subsequent use of the lock is not possible until this step has been successfully completed.

    User PIN Setup:

    • Touch the screen with the back of your hand or fingers to activate.

    • Enter the 4-8 digit Master PIN code followed by the # key.

    • Lock Response: “Menu mode, enter number, press the # key to continue”.

    • Enter “2” followed by the # key.

    • Enter “1” followed by the # key.

    • Enter the User Number to be registered (1-250) followed by the # key.

    • Enter a 4-8 digit PIN code for the User number followed by the # key.

    • To continue adding users press the # key.

    • Press the key * to complete the process and conclude the programming session.

    Note: When registering User codes, the code must be entered within 20 seconds or time expires. Lock Response: “Time expired”, no codes are registered and the process must be re-started.

    Adding Yale Lock to B.One Hub:

    In B.One App:

    • Tap on Devices. Select Add Device.

    • Under Add A Device, tap on Security and Safety and select Door Lock.

    • Select Yale Z-wave Lock.

    • In order to pair the device, tap Next.

    • Now, touch the screen with the back of your hand or fingers to activate.

    • Enter the Master PIN code followed by the # key.

    • Press number ‘7’ followed by the # key. Now press number ‘1’ followed by the # key.

    • Enter the device information. Tap Done.

    Layout inspired by HelpSite.io.